Original Autel Diagnostic Tools

I’ve got a 2020 Ford Transit from the customer, and the original key broke, none of the other key programmers can successfully add a key except the Autel MaxiIM IM608 . So I wanna show you how to do it. Connect Autel IM608 with OBD, turn ignition on, press IMMO >> VIN >> Auto detect >> Ford(USA) >> OK >> 2020 blade key >> Yes >> Hot function >> Add key(guided) Press START to execute. Note:  1. Please make sure the IM608 is connected with WIFI; 2. It is normal that the instrument panel turns black when performing this function. 3. This function will not erase existing keys. 4. You must connect VCI and Diagnostic tool using USB, otherwise, the function may fail. Yes >> Yes >> OK Is the alarm active? No Wait reading data until 100%, it takes about 10 minutes... Learned keys: 2, press “OK”. Turn the ignition off. Insert the key to be learned and turn the ignition on. The current number of keys is: 3. Learning successful....

There is an ABS traction ESP warning light on the Nissan Qashqai+2 J10(2008/8-) dashboard, so now I’m gonna use Autel MaxiCOM MK808 Scan Tool to reset it. Plug Autel MK808 connector into OBD2 port, press Diagnostics >> Nissan >> Manual selection >> Europe >> Great Britain >> Qashqai+2 >> J10 >> 2008/8- >> Yes  Diagnosis >> Control unit >> ABS >> Read codes There is a fault code C1102: RR LH Sensor-1. It is the rear left-hand sensor, I’ve put a new ABS sensor in, but I’m still getting the warning light and the fault code. So let’s go back to erase code. The ignition on and the engine off? Yes. DTC’s and freeze data will be deleted, press “Yes” to continue. Codes have been successfully erased. Return back to read codes to verify. Press “OK”. It is telling “No fault codes detected.” But the warning light is still on. Let’s turn the engine off then back on, warning light has gone! This is using Autel MK808 Diagnostic Sc...

How to update the firmware of VCI(vehicle connector interface) for Autel scan tool devices? The process is the same irrespective of the kind of Autel products, it applies to MaxiVCI Mini, MaxiVCI100 & Wireless Diagnostic Interface. This tutorial will take the MaxiVCI Mini as an example, which is used for Autel MK808TS , MX808TS, MP808TS , etc. Besides, MaxiVCI100(supports Autel MS906BT , MS908TS, etc.) & Wireless Diagnostic Interface(supports Autel MK908 , MK908P , etc) are all the same process for updating.  It is absolutely essential that beyond keeping the Autel scanner itself updated. You also need to ensure that the VCI firmware is updated so that the tool has the latest firmware for connecting to different vehicles that you may work on.  Note Before Update:  Ensure the device is well charged;  Ensure connection to VCI is firm;  Ensure Internet connection is stable. 4 Steps Of VCI Firmware Upgrade 1. Use a charging cable to connect VCI & Autel devices...